SpeedLine (SL) has been designed to provide an efficient, low-cost method of installing air compressor systems using bendable tubes and a unique round aluminum extrusion. SL is a unique round aluminum extrusion, anodized to prevent corrosion and manufactured in-line with Simplair’s advanced piping concept.

No corrosion/high-quality air

More efficient air delivery

Reduced pressure loss

Higher flow rates

Easy and fast installation

SpeedLine (SL) is available in 3 sizes: 14 mm, 22 mm, and 28 mm.

Simplair is a high-performance modular aluminum piping system that is easy to install and simple to extend or modify. The non-corrosive extruded aluminum provides structural strength and delivers contaminate-free air in a leak-free piping system. The smooth bore of Simplair tubing prevents high-pressure losses and allows for higher flow rates and performance than that of conventional piping systems. The positive O-ring seal ensures that no leaks occur at any stage of the system’s life. No air leakage ensures minimum running costs.

For a complete listing of part numbers and sizing information, please request a copy of brochure #88233135 from your local Ingersoll-Rand representative.

The Gripple Hang-Fast available from Ingersoll-Rand is the fastest and most adaptable M&E hanging system in the world. The Hang-Fast system is a quick and safe replacement for threaded rod or chain due to its fast installation, ease of use, versatility, lightweight performance and aesthetic appearance.

The Hang-Fast products come in five load-rated sizes that are value engineered to provide the most cost-effective solutions for hanging M&E services. Each size accommodates a specific range designated with a Safe Working Load (SWL), which is common to the “loop,” “stud” and “toggle” end fixing ranges.

The SWL gives a minimum 5:1 safety factor in a vertical plane and is maintained irrespective of length chosen for any designated model. Each Hang-Fast kit contains a length of steel wire rope, with a choice of three integral standard end fixings, a Gripple for height adjustment and a setting key to unlock the Gripple if required.

Loop-Fast

The “loop” anchor fixing secures the Gripple Hang-Fast to an existing structure. This method simply requires the loop end to be wrapped around the support (purlin or truss), then the tail end is fed through the loop and pulled tight.

Stud-Fast

The “stud” anchor fixing secures the Gripple Stud-Fast into a concrete structure. This method simply requires the “stud” end to be screwed directly into a drop-in anchor, which is supplied free with the kit.

Toggle-Fast

The “toggle” anchor fixing, which uses a restraining plate and end stop, secures the Gripple Toggle-Fast into a pre-drilled or punched hole. This method is ideal for attachment into metal sheeting and pressed metal fabrications with a cavity on the restraining side.

Simplair EL is designed to provide an efficient, low-cost method of installing compressed air piping systems. EL is a unique round aluminum extrusion, manufactured in-line with Simplair’s advanced piping concept.

Good-quality air

Higher flow rates

More efficient air delivery

Easy and fast installation

Reduced pressure loss

Piping can be formed by using a Simplair pipe bender (CCN 54599568)

Easy to Use Push-In System for Piping System

The Simplair EL way of push-in fittings and pipe provide the ideal connection from the compressed air receiver, throughout the entire distribution system, right to the point-of-use. Using the Simplair EL system, a compressed air system can be installed quickly and easily, considerably reducing the need for specialist staff and reducing production downtime.

No need to prepare threaded pipe or apply solvent, all the connections can be made with a simple push-in action. The system is then immediately ready for use. Complex systems can be assembled much more rapidly than with traditional methods. They are also easy to disconnect, therefore, systems are easy to alter or extend.

Simplair EL is available in 3 sizes: 15mm (5/8"), 22mm (1"), and 28mm (1-1/4").